|

EMA Resources

Video

Home > EMA Resources > Videos > Whiteboard Wednesday: RF Grounding
VIDEO

Whiteboard Wednesday: RF Grounding

This RF Whiteboard Wednesday discusses why grounding is required for RF designs and some best practices for grounding.
REQUEST INFO
    VIDEO

    Whiteboard Wednesday: RF Grounding

    Duration: 00:02:29

    RF elements are becoming increasingly present in PCB designs but require additional considerations. This RF Whiteboard Wednesday discusses why grounding is required for RF designs and some best practices for grounding.

    Learn more about incorporating RF into your PCB designs with our e-book: Making Waves with RF: A PCB Engineer’s Guide to RF Design Principles

    This video is part of a Whiteboard Wednesday Series:

    More Videos

    Videos
    OrCAD X automated trace routing

    OrCAD X Presto – Next Gen PCB Layout Interface

    Place & Route with Ease in OrCAD X's New Layout Interface
    See Videos
    Videos

    LiveDoc – Automated PCB Documentation for OrCAD X

    Live Doc is an integrated solution in OrCAD X to create fabrication and assembly drawings. Have your artwork, charts and cross-sections along side your assembly data easily displayed. Add additional views or charts and easily modify them if needed. Add annotations, dimensions and other drawing features.
    See Videos
    Videos

    AWR Tutorial: Modeling a Diode

    Learn how to create a diode model from scratch in AWR Microwave Office using a SPICE model and package parasitic provided by manufacturers.
    See Videos
    Videos

    AWR Tutorial: Slotted Line Simulation

    Learn to construct a circuit schematic of a slotted transmission line and perform analysis by changing properties using AWR Microwave Office.
    See Videos
    Videos

    AWR Tutorial: Effect of Changing Dielectric Constants on Impedance of Microstrip Line

    Learn how dielectric values effect the impedance of transmission lines and length using AWR Microwave Office.
    See Videos
    Videos

    AWR Tutorial: Effect of Changing Parameters on Impedance of Microstrip Line

    Simulate the effect on impedance when we change in width of a line and height of substrate of a microstrip line in AWR Microwave Office.
    See Videos
    Videos

    AWR Tutorial: Microstrip Line Design and Verification

    Learn how to design a microstrip line in AWR Microwave Office and verify the transmission line parameters.
    See Videos
    Videos

    AWR Tutorial: Voltage Standing Wave Ratio

    Learn what is Voltage Standing Wave Ratio (VSWR) and the effect of changing transmission line and termination on VSWR using AWR Microwave Office.
    See Videos
    Videos

    AWR Tutorial: Mismatched Transmission Lines

    Learn how to simulate and analyze mismatched transmission lines in AWR Microwave Office.
    See Videos
    Videos

    AWR Tutorial: Matched Transmission Lines

    Learn how to simulate a 50 Ohm transmission line terminated with its characteristic impedance in AWR Microwave Office.
    See Videos
    Videos

    AWR Tutorial: Frequency Response of Op Amps

    Learn how to simulate and analyze the frequency response of an Op Amp using AWR Microwave Office.
    See Videos
    Videos

    AWR Tutorial: Inverting Amplifiers with Ideal and Non-Ideal Op Amps

    Learn how to simulate ideal and non-Ideal Op Amps for inverting amplifiers and perform time domain simulation using AWR Microwave Office.
    See Videos

    Contact Us

    EMA Design Automation